Filter
Top Products
Installation and Use Manual 37
Using ProLink II Software
ProLink II Setup Transmitter StartupUsing ProLink IIBefore You Begin
3.6 Viewing process data
ProLink II provides the following windows for viewing process data and related information:
•
Process Variables window
•
Output Levels window
•
Totalizer Control window
The following windows are available if the associated option has been installed on the transmitter:
•
API Process Variables window
•
ED (Enhanced Density) Process Variables window
All of these windows are opened from the
ProLink menu. For information on the data displayed in
these windows, see the transmitter manual, the application manual, or the ProLink II help system (see
Section 3.4).
3.7 Viewing and resetting totalizers and inventories
The
Totalizer Control window is used to:
• View current values of the totalizers and inventories
• Start, stop, and reset totalizers
• Reset inventories
• Reset frequency input total (Series 3000 transmitters only)
If the enhanced density application is available and enabled in the transmitter, the
ED Totalizer
Control
window is used to view and control totalizers and inventories related to the enhanced density
application.
Inventories can be reset only if this function is enabled in the
Preferences menu.
To enable inventory reset:
1. Open the
View menu.
2. Click on
Preferences.
3. Ensure that
Enable Inventory Totals Reset is checked.
4. Click the
Apply button if necessary.
To manage totalizers and inventories:
1. Open the
ProLink menu.
2. Click on
Totalizer Control or ED Totalizer Control (if the enhanced density application is
enabled in the transmitter). A window similar to Figure 3-3 is displayed.
3. Use the buttons in this window to start, stop, or reset the totalizers and/or inventories.
Note: The
Start, Stop, and Reset buttons displayed under All Totals affect the mass totalizer, the
volume totalizer, and all API-related totalizers.
4. The
Reset Inventories button under All Totals is displayed only if this function is enabled
(see above). Use this button to reset all inventories, including API-related inventories.
Note: ProLink II does not support separate resetting of the API volume totalizer and API volume
inventory. To reset these, you must reset all totalizers or all inventories.