Filter
Top Products
Installation and Use Manual 41
Using ProLink II Software
ProLink II Setup Transmitter StartupUsing ProLink IIBefore You Begin
3.9.2 Acknowledging alarms
To acknowledge an alarm using ProLink II, you must use the
Alarm Log window. You cannot
acknowledge alarms from the
Status window.
To acknowledge an alarm:
1. Open the
Alarm Log window.
2. Check the
Ack checkbox for each alarm you want to acknowledge.
- If the alarm is no longer active (green light), the alarm will be cleared from the list, and the
Alarm Log window will be updated as soon as new data is received from the transmitter.
- If the alarm is still active (red light), the red light will remain, but the name of the alarm
will be grayed out. The alarm will be cleared from the list as soon as it is no longer active.
3.10 Managing the ProLink II license
Both the ProLink II temporary license and permanent license are keyed to a specific disk and a
specific folder or directory on a specific PC. If you want to move the ProLink II installation, you must
use the appropriate license transfer function:
•
To Directory is used to transfer ProLink II to another location on the same PC.
•
Out of Computer and Into Computer are used to transfer ProLink II to another PC.
3.10.1 Transferring to same PC
To transfer ProLink II to another location on the same PC:
1. From the ProLink II
File menu, open the License window.
2. Click
To Directory.
3. Specify the directory to which ProLink II will be transferred.
4. Install ProLink II in the new directory, following the instructions in Section 2.2.2. As part of
this procedure, you will be required to de-install the current installation.
3.10.2 Transferring to different PC
1. At the target PC (the PC to which you are transferring):
a. Install ProLink II, following the instructions in Section 2.2.2.
b. In the new installation, open the
License window.
c. Click
Into Computer and supply a diskette when requested. ProLink II will write license
transfer data to the diskette.
2. At the source PC (the PC where ProLink II is currently installed):
a. Start ProLink II and open the
License window.
b. Click
Out of Computer and insert the transfer diskette. ProLink II will copy the license to
the transfer diskette. At this point, the license is no longer valid on the source PC.
3. At the target PC:
a. In the
License window, click Into Computer.
b. Insert the transfer diskette. ProLink II will copy the license to the new installation, and you
can begin using the program in the new location.