Filter
Top Products
38 ProLink
®
II Software for Micro Motion
®
Transmitters
Using ProLink II Software
Figure 3-3 Totalizer Control window
3.8 Viewing meter status
ProLink II allows you to view a variety of status information:
•
Connection LED – located in the lower right corner of the main window (see Figure 3-1).
This LED indicates the status of the connection between ProLink II and the transmitter:
- Green – Good connection
- Red – Connection fault
- Gray – No connection
•
Device Fault Status LED – located in the lower right corner of the main window (see
Figure 3-1). This LED indicates whether or not alarms are active:
- Green – No active alarms
- Red – One or more active alarms
- Gray – Unknown
See Section 3.9 for more information about alarms.
•
Diagnostic Information window – displays sensor diagnostic data
•
Output Levels window – displays current data for the transmitter’s mA, frequency, and
discrete outputs, and also displays discrete event status
•
Status window – displays alarm status. See Section 3.9 for more information about alarms.
•
Alarm Log window – displays alarm status and alarm acknowledgment status. See Section 3.9
for more information about alarms.