Filter
Top Products
140 Universal Control Commands
FORM LENGTH
SOH A z C Length of Form in Millimeters
ASCII:
SOH A z C (n)
Control:
CTRL
AA z C (n)
Decimal:
1 65 122 67 (n)
Hexadecimal:
01 41 7A 43 (n)
Sets the form length to a specified number of millimeters. n
*
indicates
form length as follows:
•
n = 0: Form length set to 148.5 mm
•
n = 1: Form length set to 210.0 mm
•
n = 2: Form length set to 297.0 mm
•
n = 3: Form length set to 420.0 mm
If the bottom margin was previously set by the Epson or IBM Skip Over
Perforation command, ESC N, the command SOH AzC cancels the
bottom margin setting. Therefore, to re-establish the bottom margin after
this command is set, send another Skip Over Perforation command. SOH
AzC does not cancel Skip Perforation set in the configuration menu.
When the printer receives this command, the current form position
becomes the top of form.
*
(n) can be, for example, decimal 1 or ASCII character 1.