Filter
Top Products
Operator’s Guide 227
CHARACTER SETS
ESC 6 Select IBM Character Set #2
ASCII: ESC 6
Control:
CTRL
[6
Decimal: 27 54
Hexadecimal: 1B 36
This command causes the printer to print with the IBM Character Set #2.
See Appendix D for charts of character sets.
ESC 7 Select IBM Character Set #1
ASCII: ESC 7
Control:
CTRL
[7
Decimal: 27 55
Hexadecimal: 1B 37
This command causes the printer to print with the IBM Character Set #1.
See Appendix D for charts of character sets.
ESC \ All Character Character Set
*
ASCII:
ESC \ (n1) (n2)
Control:
CTRL
[ \ (n1) (n2)
Decimal:
27 92 (n1) (n2)
Hexadecimal:
1B 5C (n1) (n2)
Prints a number of characters from an All Character Set, then returns to
the character set in use prior to receipt of the ESC \ command.
n1 and n2 specify the number of succeeding characters to be printed from
this set. The total number of characters to be printed from an All
Character Character Set is equal to "n1 + (n2 x 256)". An All Character
Character Set is constructed from an IBM Code Page. (See Appendix D.)
*
ESC \ enables you to print continuously from an All Character Character Set. ESC ^ is valid for printing one character
only. Both commands enable printing of characters for data bytes normally recognized as control codes. See Appendix
D for charts of character sets.