Filter
Top Products
286 DEC LA210 Control Commands
ASCII
: ESC [ (n) t
Control
:
CTRL
[[ (n) t
Decimal
: 27 91 (n) 116
Hexadecimal
:1B5B(n)74
Sets the length of the form to n lines, not physical units. Changing the
vertical pitch (lines per in.) alters the physical form length.
The maximum value of n is determined by the current vertical lines per
inch setting, as follows:
•
6 lines per in.: n = 132, max.
•
8 lines per in.: n = 176, max.
Changing form length clears the vertical margins and defines the current
line as Line 1.
If the value of n is 0, the printer enters No Form mode. Refer to the
following command.
ESC [ Ø t No Form Mode
ASCII
: ESC [ Ø t
Control
:
CTRL
[[ Ø t
Decimal
:279148116
Hexadecimal
:1B5B3074
Causes the printer to enter No Form mode. In this mode, there are no
vertical margins or form length. Printing is continuous and line spacing is
determined by the current pitch.
This command overrides the form length setting selected from the
configuration menu. No Form mode remains in effect until the printer
power is turned off, or a new, nonzero form length is set with ESC [ (n) t.