Filter
Top Products
Operator's Guide 5
E
Check Print Quality.
Make sure the
ON LINE
indicator is lit (Page 8) and the operator
access door is closed, and then send a file from the host computer
to the printer:
•
If the print is too light or too dark (smudged), or if some dots are
not being printed, adjust the printhead gap. (See "Adjusting the
Printhead Gap," Page 27.) If necessary, replace an old ribbon
cartridge with a new one (Page 99).
•
If desired, switch between near letter quality (NLQ) and draft
quality by pressing and holding
ON LINE
and then momentarily
pressing
NLQ
. Although NLQ has more dots, and therefore
looks better than draft quality print, draft is faster.
F
Remove Printout.
1. Press
ON LINE
to place printer off line.
2. Use
FORM FEED
to move paper to a convenient tear-off point.
3. Separate printout from paper supply at perforation.
4. Press
ON LINE
again to place printer on line.