Filter
Top Products
Control Panel 43
3
3
3
3
3
3
3
3
3
3
3
3
Page length for tractor
This setting allows you to set the page length (in inches) for the
continuous paper loaded on the tractor.
Skip over perforation
This feature is available only when continuous paper is selected
as the paper source. When you turn on this feature, the printer
provides a one-inch (25.4 mm) margin between the last line
printed on one page and the first line printed on the next page.
Because most application program margin settings override
margin settings from the control panel, you should use this setting
only if you cannot set your top and bottom margins using your
application.
Auto tear-off
When auto tear-off is on and you are using continuous paper, the
printer automatically advances the paper perforation to the
tear-off position, where you can easily tear off the printed page(s).
When the printer receives data again, it automatically moves the
paper back to the top-of-form position and starts printing, so you
can use all of the next page. When using continuous paper, it is a
good idea to set the Auto tear-off function.
Auto line feed
When auto line feed is on, the printer accompanies each carriage
return (CR) code received with a line feed (LF) code.
Print direction
You can select auto print direction, bidirectional printing (Bi-D),
or unidirectional printing (Uni-D). Printing is normally
bidirectional; however, unidirectional printing allows for precise
vertical printing alignment.
Software
When you select ESC/P2, the printer operates in the EPSON
ESC/P2 mode. When you select IBM PPDS, the printer emulates
an IBM printer.