Filter
Top Products
96 Maintaining the Projector
Replacing the Lamp
The projection lamp typically lasts for about 1500 hours of use. It is
time to replace the lamp when:
■ The projection image gets darker or starts to deteriorate.
■ The lamp warning light is red or flashing red.
■ The message LAMP REPLACE appears on the screen when the
lamp comes on (after about 1400 hours of use). To maintain
projector brightness and image quality, replace the lamp as soon
as possible.
Contact your dealer or call EPSON at (800) 873-7766 in the United
States for a replacement lamp. Request part number
V13H010L18. In
Canada, please call (800) 463-7766 for dealer referral
Follow these steps to replace the lamp:
1. Turn off the projector, wait for it to cool down (when the light
stops flashing), then unplug the power cord.
2. Allow the projector to cool for at least half an hour (if it has been
on).
3. Turn the projector over, then release the tabs to remove the cover.
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
If your projector is mounted
on the ceiling, you should
unmount it before accessing
the lamp compartment. This
makes it easier for you to
replace the lamp and
minimizes the chance of any
small glass fragments
dropping from the projector.