Filter
Top Products
10 Displaying and Adjusting the Image
Projecting the Image
Make sure your projector and other equipment are set up as described
in Chapter 3 (for wireless network presentations), Chapter 4 (for
directly connected computer or video equipment), or Chapter 5 (for
memory card presentations). Then follow the instructions below to
start the projector and display an image.
Turning on Your Equipment
If you’re projecting from computer or video equipment that’s directly
connected to the projector, turn it on before starting the projector;
this lets the projector automatically detect the image source.
Otherwise, you may need to select the image source after you turn on
the projector.
Turning on the Projector
Follow these steps to turn on the projector:
1. Remove the lens cap.
2. Plug in the projector, as shown below.
The P power light on top turns orange, indicating that the
projector is receiving power.
note
To shut down the projector,
see page 20. Shutting down
the projector correctly
prevents premature lamp
failure and possible damage
from overheating.