Filter
Top Products
Displaying and Adjusting the Image 13
To remove a card that’s already in the projector, follow these
guidelines:
■ For the 802.11b card, simply pull it straight out of the card slot.
■ For a memory card, push in on the eject button so the button
extends out (if it’s not already). Then push it a second time to
eject the card.
Using Component Video
If you want to project using component video, make sure your video
equipment is properly connected to the Computer/Component Video
port as described on page 48. Then follow these steps:
1. First switch the source to
Computer, using either the Source
button on the projector or the
Comp/EasyMP button on the
remote control.
2. Then change the
Input Signal in the Video menu to the YCbCr
or
YPbPr Component Video setting (see page 77).
Pressing the
Comp/EasyMP button on the remote control (or the
Source button on the projector) then lets you switch to Component
Video—instead of Computer—as the input signal.
note
You don’t have to turn off
the projector before inserting
or ejecting cards.
Push button to
eject card
Card slot