Filter
Top Products
Setting Up the Printer
1-11
R
R4C7930
shrimp.bk Rev.C
shrimpsetup.fm A5 size
11/26/01 Pass 1
Proof Sign-off:
ABE Y. Azuma A. Nagasawa
T. Takahashi
ABE S. Halvorson
3. Slide the interface card along the slots on both sides of the
interface compartment. Firmly push in the card to make sure
the connector at the back of the card is fully inserted into the
printer’s internal socket. Then replace the screws and tighten
them.
To remove the interface card, reverse the steps above.
Plugging in the Printer
Follow these steps to plug in the printer:
1. Make sure the printer is turned off.
Store the shield plate in
a safe place; you will
need to reattach it if
you remove the
interface card later.
The printer is off when the
power switch is pressed
down to the N side.