Filter
Top Products
3-2
Using the Control Panel
L
R4C7930
shrimp.bk Rev.C
shrimpcp.fm A5 size
11/26/01 Pass 1
Proof Sign-off:
ABE Y. Azuma A. Nagasawa
T. Takahashi
ABE S. Halvorson
Tear Off/Bin light
Flashes when continuous paper is in the
tear-off position.
On when bin 1 of the optional cut-sheet
feeder is selected.
Off when bin 2 of the optional cut-sheet
feeder is selected.
5
LF/FF button
Feeds paper line by line when pressed
quickly.
Ejects a single sheet or advances
continuous paper to the next top-of-form
position when held down.
6
Micro Adjust
When you hold down the Pause button for
three seconds, the printer enters the micro
adjust mode. In this mode, you can press the
LF/FF
D and Load/Eject
U buttons to adjust
the top-of-form or tear-off position. See
“Using the Micro Adjust Function” on
page 2-27.
7
Load/Eject button
Loads a single sheet of paper.
Ejects a single sheet of paper.
Loads continuous paper from the standby
position.
Feeds continuous paper backward to the
standby position if a sheet is loaded.
8
Pause light
On when the printer is paused.
Flashes when the printer is in the Micro Adjust
mode.
9
Pause button
Stops printing temporarily, and resumes
printing when pressed again.
When held down for three seconds, enters
the Micro Adjust mode. When pressed
again, exits the Micro Adjust mode.
10
Lock
When Lock-out mode is on, the Paper Out
and Pause lights flash if a locked button is
pressed.
11
Paper Out light
On when no paper is loaded in the selected
paper source or paper is not loaded
correctly.
Flashes when paper has not been fully
ejected or a paper jam has occurred.