Filter
Top Products
Using the Control Panel
3-11
R
R4C7930
shrimp.bk Rev.C
shrimpcp.fm A5 size
11/26/01 Pass 1
Proof Sign-off:
ABE Y. Azuma A. Nagasawa
T. Takahashi
ABE S. Halvorson
1. Make sure paper is loaded and the printer is turned off.
2. Turn on the printer while holding down the LF/FF and
Pause buttons. The printer enters the Lock-out setting mode
and prints the instructions. (You’ll need three sheets of A4 or
letter size single-sheet paper or three pages of continuous
paper that is at least 279 mm [11 inches] long and 210 mm
[8.3 inches] wide.)
3. Follow the instructions to change the settings as desired.
4. Turn off the printer.
See “Turning Lock-out mode on and off” on page 3-10 for
instructions on how to turn on Lock-out mode after you change
the Lock-out mode setting.
Emulating the Okidata Microline 320 Turbo
If you have the EPSON FX-880+, you can make it work like the
Okidata
®
Microline
®
320 Turbo by turning the printer on in a
different mode. In Okidata mode, the printer emulates Okidata
functions, and the following additional settings can be selected
in the default setting mode:
Micro Adjust Locked
Font Locked
Pitch Locked
Pause Unlocked
Reset Locked
Feature Printer settings in Okidata mode
Software emulation IBM PPDS, EPSON ESC/P, Oki ML 320T
Auto tear off wait time 0.5 second, 1 second, 2 seconds,
Others
Bottom margin 4.2 mm, 20 mm, 22 mm, 24 mm, Others
Line spacing (lines per inch) 6 LPI, 8 LPI
Paper out override Off (No), On (Yes)