Filter
Top Products
3-8
Using the Control Panel
L
R4C7930
shrimp.bk Rev.C
shrimpcp.fm A5 size
11/26/01 Pass 1
Proof Sign-off:
ABE Y. Azuma A. Nagasawa
T. Takahashi
ABE S. Halvorson
Manual feed wait time
The printer is set to wait 1.5 seconds between feeding sheets
manually, but you can change it to 1, 2, or 3 seconds if necessary.
Buzzer (beeper)
The printer beeps when an error occurs. If you don’t want the
printer to beep when an error occurs, turn off this setting.
Auto CR (carriage return)
This setting is available only in IBM PPDS emulation mode.
When auto carriage return is on, each line feed (LF) code or
ESC J code is accompanied by a carriage return (CR) code so the
printer moves the next printing position to the left margin.
When this setting is off, you must send a CR code after the line
feed code to move the printing position to the left margin.
IBM character table
This setting is available only in IBM PPDS emulation mode.
When you select Table 1, hex codes 00H to 1FH and 80H to 9FH
of the character tables are used for the control codes. When you
select Table 2, hex codes 00H to 1FH are used for the control
codes and 80H to 9FH are used for characters.
Bottom margin
When the printer is in Okidata mode, you can change the length
of the bottom margin (the area between the last printable line
and the bottom of the sheet).
Line spacing
When the printer is in Okidata mode, use this setting to change
the number of lines printed per inch.
Paper out override
When the printer is in Okidata mode, you can turn this setting
on to disable the paper out function and print beyond the
bottom margin. Then you can press the LF/FF button for each
extra line you want to print until you reach the bottom limit.