FARGO electronic 400 Printer User Manual


 
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
5-4
Network Management Interface
The SNMP interface is described below.
Interface Description
SNMP
The Ethernet interface is a fully-manageable SNMP agent that supports
MIB-II.
The Ethernet interface is MIB II compliant, allowing SNMP managers to
monitor protocol, network and routing statistics.
Telnet Command Line Interface
Initiating a Telnet Session
This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer. Follow these instructions to issue Telnet commands.
Step Description
1 Identify the IP address of your Printer. (Note: See the Accessing the IP
address of your Printer.)
2 Initiate a Telnet session from a DOS window on your PC. At the DOS prompt,
enter telnet [IP Address]
Example: C:\>telenet 192.168.11.12
All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
All commands entered will be sent to the Telnet client in the Printer.
3 Enter help or ? to get an on-window list of supported Telnet commands.