Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.6)
3-13
Flipper Table Module Installation
The Flipper Table Module Assembly (D900200) is an automated Flipping Module that allows
the Printer to print on the front side and back side of each card.
• See the Installing the Flipper Table Module Assembly (D900200)
procedure.
• See the Flipper Table Module Assembly Problems
procedures.
• See the Print Both Sides option in the Using the Device Options tab (DTC400)
section.
• See the Front and Back radio buttons in the Using the Overlay / Print Area tab (DTC400)
section.
• See the Front and Back radio buttons in the Using the K Panel Resin tab (DTC400)
section.
• See the DTC400 Card Printer Service Manual for the replacement procedures for this
Printer.