Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
5-19
Troubleshooting with the LCD Error Message Table (continued)
LCD Error Message Cause Solution
Remove Lam Mtl
(PC Error Message
No. 210)
Single Sided Lam job
specified but the material is
loaded in both Modules.
Remove either Lamination
Cartridge.
Remove Lam1 Mtl
(PC Error Message
No. 204)
Single sided lamination on
the back side is specified but
material is loaded in the Lam
1 Module.
Remove Cartridge 1.
Remove Lam2 Mtl
(PC Error Message
No. 205)
Single sided lamination on
the front side is specified but
material is loaded in the Lam
2 Module.
Remove Cartridge 2.
Ribbon Break/Jam
(PC Error Message
No. 99, 108, and
109)
The Ribbon is not able to
find the next panel correctly.
Check for jams/breaks.
If jammed, clear the jam. If
broken, repair by taping the
Ribbon back on to the take-up
core.
Press Resume to continue or
Cancel to abort.
Ribbon Low
(PC Error Message
No. 92)
The print Ribbon will soon
run out.
If printing a large number of
cards, replace the Ribbon now
or monitor the Printer until the
Ribbon is gone and install a
new Ribbon.