FARGO electronic Pro-LX Laminating Card Printer/Encoder Printer User Manual


 
RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 190
Replacing the Cleaning Tape (continued)
Step Procedure
4 Push the spring-loaded Release Tab in and lift the used cleaning tape and the
two (2) Tape Rollers out of the Cartridge, as shown below. (Note: The
permanent Cleaning Rollers should stay within the Cartridge.)
5 Insert the two (2) Tape Rollers into the new Cleaning Tape loop.
6 a. Push in the spring-loaded Release Tab and place the Tape Rollers and the
new tape back into the cartridge.
b. Be sure to orient the new tape loop so that it extends over the end of the
cartridge.
7 Pull on the Tape Loop's Tab to remove the backing from the tape.
8 a. Insert the Cleaning Cartridge back into the Printer as shown.
b. Be sure to insert the cartridge with the Release Tab toward the input end of
the Printer.
Caution: If the cartridge is not inserted properly, the Printer will not
feed cards.
Release Tab