Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 6
Reviewing Pro-LX Boot Up Sequence
Step
Process
1 On Power up, print and the Lam Stepper Motor engage.
2 Print and Lamination Headlift Sensor checks for current open/closed state.
If either Sensor registers closed, the appropriate Headlift Motor engages until
Headlift Sensor detects open state.
3 Check SmartCard and Mag Sensors for presence of card.
If there is a card found in either location, the print and Lam Stepper Motors engage
to back the card out onto the flipper table.
4 Print TOF, Card Detection and LAM TOF Sensors check for presence of card.
If any Sensor finds a card, the card is fed onto the flipper table. The flipper table
then rotates and ejects the card into the reject bin.
5 The Flipper Clutch activates.
6 The Lam Stepper Motor engages.
7 The Flipper Home Sensor detects the homing flag and the Flipper Table levels.
8 The Flipper Clutch disengages
9 The Lam Stepper Motor disengages.