Filter
Top Products
99
6
DONOR/RECEIVER JAM CLEARING PROCEDURES
1
.
Open the front lower door, raise the thermal processing unit
release lever "J11", and slowly open the thermal processing
unit to the right.
NOTE: At this time, remove any jammed receiver.
CAUTION:
The thermal processing unit is hot. Do not touch the thermal
processing unit immediately after opening it.
2
.
Close the front lower door and open the front upper door.
3
.
Open the right-hand side upper door.
4
.
Push up the water coating section and rotate the "J3" knob
counter clockwise to cause the donor to come out. Remove
the donor and slowly replace the water coating section to
its original position.
6.4 Jamming at Location "3"
Thermal
Processing
Unit
Front Upper
Door
"J11" lever
Right-hand Side Upper Door
"J3" knob
Donor
Water Coating
Section