Filter
Top Products
32
● There is a receiver end detection hole on the trailing edge of the receiver. When this hole is
detected by the machine, the receiver's trailing edge is discharged as described below.
● Replace the receiver magazine when the R LED on the transfer monitor comes on.
NOTE: If the donor or receiver magazine is left in a room or in a hot and damp place for a long time, print quality
deterioration may result. Store the magazines in a cool dark place away from direct sunlight. When
stored for over a month, keep them at 10°C, 60%RH or less.
● After replacing the receiver, replace the water (see Section 3.6) and dispose of the refuse (see
Section 3.7).
3.5 Receiver Magazine Replacement
■ The trailing edge discharge
★ When the receiver is used up, the message changes
to "End Process" and the receiver trailing end is
discharged after about 3 minutes.
★ When the discharge is completed, the message
changes to "Warning Paper Empty", the R LED lamp
on the transfer monitor comes on, and the alarm sounds
(four successive short beeps, repeated).
Replace the receiver magazine by doing the procedure below.
1
.
Make sure that LED lamps 1 to 10 on the transfer monitor
are off. Open the front upper door and pull the receiver
magazine straight out.
IMPORTANT:
Do not open any door while LED lamps 1 to 10 on the
transfer monitor is on. If you do, donor/receiver jamming
may occur.
2
.
Unlock both sides of the receiver magazine and open the
cover of the magazine.
Paper End Process
Warning
Donor Empty
Receiver
Magazine
Front Upper Door