Filter
Top Products
41
3
OPERATING PROCDURES
To turn the power switch to OFF ( ), follow the steps below.
1
.
Make sure that LED lamps 1 to 10 on the transfer monitor
are off.
IMPORTANT:
● If any of the LED lamps (1 to 10) on the transfer monitor
is on, wait until all receivers are discharged.
If the power switch is set to OFF (
) during this time,
the paper stops inside the machine and a jam error
occurs the next time the power switch is set to ON.
● If a power failure, inadvertent power OFF, or power plug
disconnection occurs during printing, set the power
switch to ON ( ) again, check inside the machine and
remove any paper remaining in the transfer section.
2
.
Set the power switch to OFF ( ).
IMPORTANT:
● Do not turn the power switch ON and OFF in short
intervals since this may cause the machine to
malfunction.
● While the power switch is turned OFF ( ), do not open
the inner door because the donor may be exposed to
extraneous light, which could result in abnormal print
production.
● If the machine is not to be used for period longer than
one week, remove the donor and receiver magazines
from the machine and store them in a cool dark place,
and empty the water bottle.
3
.
Make sure that all the lamps on the operation panel are off.
NOTE: Use care when disconnecting the power plug.
WARNING:
Do not touch the power plug with wet hands as this may result
in an electrical shock.
CAUTION:
When disconnecting the power plug, always hold the plug.
Pulling the power cable may expose the conductor or snap the
wires, which may cause a fire or electrical shock.
3.8 Turning OFF the Power
ON LINE
DATA
Power Switch
ON LINE
DATA