Filter
Top Products
37
3
OPERATING PROCDURES
6
.
Pour water into the water bottle.
IMPORTANT:
● Do not use well water. Use tap water for drinks at a
temperature of between 20°C and 40°C.
● If the water temperature is below 20°C, it may take longer
for the machine to become ready for printing; this,
however, does not constitute a machine failure.
7
.
Keep pouring until the water reaches the upper- and lower-
limit lines (approx. 1.1 liters), and then reattach the cap.
IMPORTANT:
If the upper-limit line is exceeded, the water may overflow
when the machine is operated.
8
.
Insert the water bottle into the machine.
9
.
Remove the stopper from the water bottle and insert the
water supply hose into the water supply port.
IMPORTANT:
If the water supply hose is not properly inserted into the
water supply port, the water will not adequately be drawn.
This may result in image quality inconsistency or donor/
receiver jamming.
10.
Close the front upper door.
★ The message changes to "Self Check" and the machine
starts the selfcheck.
★ When the self-check operation is completed, the
message changes to "Data Ready".
3.6 Water Replacement
Water Inlet
Water Inlet
Cap
Upper-limit Line
Lower-limit Line