Filter
Top Products
29
3
OPERATING PROCDURES
6
.
Take out the core from the donor magazine and adjust the
partition to the size of the donor being used.
The size of the donor corresponds to the size of the receiver,
as shown in the table below.
Size of donor Corresponding size of receiver
323mm 315 mm (Double Letter Wide,etc.)
305mm 279 mm (Double Letter and Letter)
262mm 254 mm (10 x 12 and 10 x 8)
135mm 127 mm (4R and 5R,etc.)
NOTE: Use the proper combination of donor and receiver. Do not use
combinations other than those above. If you do, the message
"Warning Check Magazine Type" appears.
7
.
Take out the donor roll along with the light-blocking leader
out from the casing and insert the plastic flanges into the
right-hand and left-hand sides.
8
.
Insert the donor roll into the donor replacement magazine
for which the partitions were set in step 5.
3.4 Donor Magazine Replacement
323mm
305mm
262mm
135mm
Partition