Filter
Top Products
Setup Mode
USING SETUP MODE
User's Manual 5-33
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
<PPR-OUT> CNTONLY DETECT IGNORE
Procedure
To change the printer’s hardware options, make sure that continuous
forms are loaded and then proceed as follows:
1. Enter setup mode.
Press the FONT button and the MENU button simultaneously
until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is
printed:
2. Select the HARDWRE function.
Repeatedly press the LOCK button to position the red cursor
under HARDWRE. Press the FONT button to select the
HARDWRE function and print the first item and its options, as
shown below:
3. Select an option for the selected item.
Press the LOCK button to move the cursor to the option you
require. Press the FONT button to select the option and print
the next item.
NOTE
To print the previous item, press the MENU button.
4. Repeat step 3 until all required options are changed.
5. Exit the HARDWRE function.
Press the ONLINE button to exit the HARDWRE function and
reprint the <<FUNCTION>> menu.
#05 Chapter 5 2000.09.20, 2:37 PM33