Filter
Top Products
SETTING UP
2-14 User's Manual
2. Raise the cut sheet stand. Move the left paper guide all the way
to the right. Insert the sheet of paper into the cut sheet stand.
Letter or A4 size paper, inserted lengthwise (portrait mode) with
this setting, will not result in clipping.
Adjust the right paper guide so that the paper lies flat on the cut
sheet stand.
3. Slide the paper along the cut sheet stand until its bottom edge
touches the platen. Then press the LOAD button. The paper
will be loaded to the top-of-form position.
Printing the Self-Test
The printer has a built-in self-test program. The self-test prints the
firmware version, the names of the printer’s resident emulations, and
all of the characters available in the emulations. The self-test prints 80
characters per line. If you are using a color printer and ribbon, printing
is in seven colors.
To print a self-test page, make sure that a sheet of paper is loaded.
Then proceed as follows:
1. Turn the printer off.
2. While pressing the LF/FF button, turn the printer back on.
Keep the LF/FF button pressed until the printer beeps. Self-test
printing will start.
#02 Chapter 2 2000.09.20, 2:31 PM14