Filter
Top Products
Maintenance
User's Manual 6-7
MAINTENANCE
Head lock wire
REPLACING THE PRINT HEAD The print head is easy to replace.
CAUTION
The print head may be hot if you have been printing recently.
To remove the print head:
1. Turn off the printer.
2. Open the front cover of the printer and remove the ribbon
cartridge.
3. Pull the right end of the head lock wire forward to release it
from the hook at the right of the print head carriage. Then
release the wire from the center hook.
4. Remove the print head from the connector on the carriage, as
shown in the figure below.
Replacing the print head
#06 Chapter 6 2000.09.20, 2:38 PM7