Filter
Top Products
USING SETUP MODE
User's Manual5-10
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
PRINTING A LIST OF
SELECTED OPTIONS
The LIST function prints a list of all the printer’s currently selected
options. This function is useful for checking the printer settings when
you first enter setup mode or just before you exit. To print a list of
options, load continuous forms paper and then proceed as follows:
1. Enter setup mode.
Press the FONT button and the MENU button simultaneously
until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is
printed:
2. Select the LIST function.
Repeatedly press the LOCK button to position the red cursor
under LIST. Next press the FONT button or the MENU button
to select the LIST function. The printer starts to print a list of
the currently selected options. The preselected factory
settings, also called factory defaults, are shown on the opposite
page.
When the printer finishes printing the list of options, it reprints
the <<FUNCTION>> menu.
NOTE
To remove the printout, turn the platen knob until the paper
can be torn off at the perforation. In setup mode, you cannot
use the printer tear-off feature (TEAR OFF button).
3. Do either of the following:
• Select another function, or
• Exit setup mode, saving any changes you made.
For details about other functions, see the other sections in this
chapter. To exit setup mode and save your changes, make sure
that the red cursor is positioned beneath SAVE & END, then
press the FONT button or the MENU button.
#05 Chapter 5 2000.09.20, 2:36 PM10