Filter
Top Products
User's Manual
Paper
Handling
PAPER HANDLING
3-19
(136-column printer)
Pull the separator to the front of the printer.
6. Position the catches of the tractor unit on the support studs near
the platen shaft, push the tractor unit toward the front of the
printer ( ➀ ), and snap down the tractor unit into place ( ➁ ).
Turn the platen knob to make sure that the tractor gear fully
engages the platen shaft gear. Lean the separator against the
tractor unit.
Installing the tractor unit for pull-tractor feed
The following are procedures when you want to feed continuous forms
paper from under the printer (bottom feed).
To load continuous forms paper:
1. Turn off the printer.
2. Make sure that the paper path slot of the printer is adjusted
with the desk or the printer rack slot.
3. Set the paper thickness lever to position D (widest gap).
4. Move the paper select lever to the rear (continuous forms).
5. Open the front cover.
Support studs
#03 Chapter 3 2000.09.20, 2:33 PM19