Filter
Top Products
PAPER HANDLING
User's Manual3-16
6. Fit the paper feed holes onto the left and right tractor pins.
Adjust the left tractor (as seen from the rear of the printer) to the
width of the form. Close the paper holders.
Cut sheet
stand
Adjusting paper tension
7. Pull the left tractor (as seen from the rear) to stretch the paper
taut. Push the left locking lever down to secure the tractor in
place.
8. Reinstall the cut sheet stand. For installation, see the section
Installing the Cut Sheet Stand in Chapter 2.
9. When using paper-stapled multipart forms, raise the cut sheet
stand to the up position. For other continuous forms paper,
lower the cut sheet stand to the down position.
Lowering the cut sheet stand
Paper holders
#03 Chapter 3 2000.09.20, 2:33 PM16