Filter
Top Products
Setup Mode
USING SETUP MODE
User's Manual 5-37
Procedure
Before adjusting a print position, you should carefully measure the
amount of adjustment required for any paper that demands precise
print registration. To adjust a print position, make sure that continu-
ous forms paper is loaded. The following example shows how to
adjust the top-of-form setting for continuous forms.
1. Enter setup mode.
Press the FONT button and the MENU button simultaneously
until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is printed:
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
2. Select the ADJUST function.
Repeatedly press the LOCK button to position the red cursor
under ADJUST. Press the FONT button or the MENU button
to select the ADJUST function and print the following
<CNT-ORG> options:
<CNT-ORG>
1/6IN 2/6IN 3/6IN 4/6IN 5/6IN 6/6IN 7/6IN 8/6IN 9/6IN 10/6IN
11/6IN ....
3. Select an option from 1/6IN to 66/6IN.
Press the LOCK button to move the cursor to the required
option. Press the FONT button to select the option and print
the <CNTFINE> item. If necessary, fine-tune the top-of-form
position now. Otherwise, go to step 4.
4. Exit the ADJUST function.
Press the ONLINE button to exit the ADJUST function and
reprint the <<FUNCTION>> menu.
#05 Chapter 5 2000.09.20, 2:37 PM37