Filter
Top Products
User's Manual
Paper
Handling
PAPER HANDLING
3-5
USING SINGLE SHEETS This section describes how to load paper in the cut sheet stand or cut
sheet feeder. The cut sheet stand allows paper to be loaded manually,
one sheet at a time. A cut sheet feeder allows paper to be loaded
automatically from a stack.
Loading a Single Sheet of Paper
To load a sheet of paper into the cut sheet stand:
1. Make sure that the printer is turned on. Check that rear-fed
continuous forms are retracted to the park position. (For
details, see the section Unloading Continuous Forms later in
this chapter.)
Table 3.2 Paper Thickness Lever Settings
Number of Copies
(Including the Original) *1
1 copy 1
2 copies 2
3 copies 3
4 copies 4
5 copies 5
Ribbon replacement D
*1 For carbon-interleaved paper, the carbon counts as one copy.
*2 Vary the setting up or down (including A to D) to optimize
printing. Select D when replacing a ribbon or clearing a paper
jam. For labels and envelopes, use trial-and-error to determine
a satisfactory setting.
NOTE
If printing is messy, the ribbon misfeeds, or the paper jams,
move the lever one setting higher.
Setting *2
#03 Chapter 3 2000.09.20, 2:32 PM5