Filter
Top Products
Zebra XiII Printer User’s Guide 5
Getting Started
Storage and Reshipping
If you are not placing the XiII printer into operation immediately, repackage
it using the original packing materials. The XiII printer may be stored under
the following conditions:
• Temperature: -4° to +140° F (-20° to +60° C)
• Relative humidity: 5 to 85% non-condensing
To ship the Zebra XiII-Series printer, carefully pack it in a suitable container
to avoid damage during transit. Whenever possible, use the original con-
tainer from the factory. A shipping container can be purchased from Zebra
Technologies Corporation if the original one is lost or destroyed. If you use
a different container, package the printer carefully to avoid damage. Zebra
will not be responsible for shipping damage incurred due to improper pack-
aging!
CAUTION: When packaging the printer in a rigid container, use shock mounts or shock-
absorbing packing material. A rigid container will allow shock on the out-
side to be transmitted undamped to the printer which may cause damage.
Also, before packing, remove all ribbon and media from the supply and
take-up/rewind spindles to prevent damage to the printer.
Site Requirements
CAUTION: To insure that the printer has proper ventilation and cooling, do not place
any padding or cushioning material under the unit because this restricts air
flow.
The Zebra XiII-Series printer may be installed on any solid, level surface of
sufficient size and strength to accommodate the physical dimensions and
weight of the unit. The area enclosure in which the printer will operate must
meet the environmental conditions specified. Electrical power must be
available and in close proximity to the printer.
xi2ch1 Page 5 Tuesday, April 23, 1996 12:22 PM