Genicom 140 TM Printer User Manual


 
Getting Started
6 Zebra XiII Printer User’s Guide
Since the Zebra XiII-Series printer was designed and is fabricated as an
industrial-type unit, it will function satisfactorily in areas such as ware-
houses, factory floors, and office environments that conform to specified
environmental and electrical conditions.
Printer Power-Up
Follow the instructions in this section to connect this printer to a source of
electrical power and a data source.
Voltage Selection
The XiII printer auto-adjusts for 90-264 VAC electrical power. No further
adjustment is required.
Power Cord
WARNING! For personnel and equipment safety, always use a three-prong plug with a
ground (earth) connection.
Make sure that the Power On/Off Switch (located at the back of the printer)
is in the off position before connecting the power cable to an electrical out-
let.
Depending on how your printer was ordered, a power cord may or may not
be included. If one is not included, or if the one included is not suitable for
your requirements, refer to “Power Line Cord Specifications” on page 87.
The power cord connector must be plugged into the mating connector on the
rear of the printer.
xi2ch1 Page 6 Tuesday, April 23, 1996 12:22 PM