Filter
Top Products
Zebra XiII Printer User’s Guide 13
Getting Started
8. Media loading is now complete. See “Adjusting the Transmissive Media
Sensor Assembly Position” on page 15.
Rewind Mode for Printers With the Cutter Option
1. Remove the Media Rewind Plate from its storage location in front of the
print mechanism inside the media compartment.
2. Invert the Rewind Plate so that the lip on the attached Hook Plate points
down.
3. Insert the Hook Plate lip a short distance (½") into the lower opening in
the Side Plate and slide the Rewind Plate in so that it stops against the
printer’s main frame.
4. Insert the two small tabs on the Rewind Plate into the corresponding
slots in the Cutter Support Bracket. (The Rewind Plate should spring into
the proper position.)
5. Load the media as described in the instructions for Roll Media Loading
on page 10.
6. Remove the Hook from the Rewind Spindle.
7. Route the media as shown in Figures 1 and 2 and wind it once or twice
around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3”
core.
8. Media loading is now complete. See “Adjusting the Transmissive Media
Sensor Assembly Position” on page 15.
xi2ch1 Page 13 Tuesday, April 23, 1996 12:22 PM