Filter
Top Products
Getting Started
10 Zebra XiII Printer User’s Guide
Roll Media Loading
Place the media roll on the Media Supply Hanger and thread the media
through the printhead assembly as shown in the “Tear-Off” loading part of
Figure 2. Flip up the Media Supply Guide and adjust the Media Supply
Guide and the Media Guide against the outer edge of the media. These
guides must not cause pressure or excessive drag on the media. Close the
Printhead Open Lever and see “Adjusting the Transmissive Media Sensor
Assembly Position” on page 15.
Fanfold Media Loading
Fanfold media, from outside the printer, feeds through either the bottom or
rear access slot. You may also use the Fanfold Supply Bin to hold media
inside the printer housing.
Figure 2. Roll Media Loading
xi2ch1 Page 10 Tuesday, April 23, 1996 12:22 PM