Filter
Top Products
Getting Started
12 Zebra XiII Printer User’s Guide
Cutter Mode Media Loading
(Cutter Option Required)
Figures 2 and 3 illustrate a printer equipped with the Cutter Option. To
ensure proper media loading, follow the directions for the Tear-Off Mode
with the exception that the media must also be routed through the Cutter
Module as shown in Figures 2 and 3.
Close the Printhead Open Lever. The printer will automatically feed out and
cut one label when the printer is powered on. Turn to “Adjusting the Trans-
missive Media Sensor Assembly Position” on page 15
Rewind Mode Media Loading
(Rewind Option Required)
Rewind Mode Configuration for Printers Without the
Cutter Option
1. Remove the Media Rewind Plate from its storage location in front of the
print mechanism inside the media compartment.
2. Invert the Rewind Plate so that the lip on the attached Hook Plate points
down.
3. Insert the Hook Plate lip a short distance (½") into the lower opening in
the Side Plate.
4. Align the upper end of the Rewind Plate with the corresponding opening
in the Side Plate and slide the Rewind Plate in so that it stops against the
printer’s main frame.
5. Load the media as described in the instructions for Roll Media Loading
on page 10.
6. Remove the Spindle Hook from the Rewind Spindle.
7. Route the media as shown in Figures 1 and 2 and wind it once or twice
around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3”
core.
xi2ch1 Page 12 Tuesday, April 23, 1996 12:22 PM