Filter
Top Products
Operation
32 Zebra XiII Printer User’s Guide
An asterisk (*) in the upper left hand corner of the display indicates that the
value displayed is different than the currently stored value.
Changing Password-Protected Parameters
Certain parameters are password-protected by factory default.
CAUTION: Do not change password-protected parameters unless you’re sure you know
what you’re doing! If they are set incorrectly, these parameters could cause
the printer to function in an unpredictable way.
The first attempt to change one of these parameters (pressing one of the
black oval keys) will require you to enter a four-digit password. This is
done via the
display. The left black oval key changes
the selected digit position. The right black oval key increases the selected
digit value. After entering the password, press the Next/Save key. The
parameter you are trying to change will be displayed. If the password was
entered correctly, you can now change the value.
The default password value is 1234. The password can be changed using the
^KP (Define Password) ZPL II
instruction.
Note: Once the password has been entered correctly, it will not have to be entered
again unless you leave and re-enter the programming mode using the Setup/
Exit key.
Note: You can disable the password protection feature so that it no longer prompts
you for a password by setting the password to ØØØØ via the ^KPØ ZPL/
ZPL II command. To re-enable the password-protection feature, send the
ZPL/ZPL II command ^KPx, where “x” can be any number, 1-4 digits in
length, except Ø.
Leaving the Program Mode
You can leave the Program Mode at any time by pressing the Setup/Exit
key. The display will appear. There are five choices,
xi2ch2 Page 32 Tuesday, April 23, 1996 1:45 PM