Filter
Top Products
Zebra XiII Printer User’s Guide 51
Operation
Sample ZPL II Label Formats
ZPL II
®
is Zebra Technologies Corporation's Zebra Programming
Language II label design language. ZPL II lets you create a wide variety of
labels from the simple to the very complex, including text, bar codes, and
graphics.
This section contains three sample label formats for you to begin experi-
menting with. It is not intended as an introduction to ZPL II
. To learn about
ZPL II , send in the request card at the beginning of this book for a free copy
of the ZPL II Programming Guide.
For each format, do the following:
1. Set up the printer and turn the power on.
2. Use a text editing program (ex: Windows™ Write or DOS Editor) and
type in the label format exactly as shown in the sample label format
below.
3. Save the file in a directory for future use. Use the extension “ . zpl”.
4. Copy the file to the Zebra XiII printer.
Note: Typically, computers running DOS use the “COPY” command to send a file
to the Zebra printer. For example, if your file name is “format1.zpl” then
type, “COPY FORMAT 1.ZPL XXXX”, where “XXXX” is the port to
which your Zebra printer is connected, for example, “COM1” or “LPT1”.
5. Compare your results with those shown. If your printout does not look
like the one shown, confirm that the file you created is identical to the
format shown, then repeat the printing procedure. If nothing prints, refer
to Chapter 1 to make sure your system is set up correctly, otherwise refer
to Chapter 4, “Troubleshooting and Diagnostics.”
xi2ch2 Page 51 Tuesday, April 23, 1996 1:45 PM