Filter
Top Products
2. Disconnect one connector (callout 1). and then, while pressing the lever (callout 2), release two
tabs (callout 3) on the bottom of the cartridge presence sensor to remove it from the product.
Figure 1-123 Remove the cartridge presence sensor
2
3
1
Right door sensor
1. Remove the following components or assemblies:
●
Front cover. See
Front cover on page 11.
●
Right front lower cover. See
Front right lower cover on page 15.
●
Rear cover. See
Rear cover on page 13.
●
Formatter cage. See
Formatter cage assembly on page 52.
●
Right rear cover. See
Right rear cover on page 12.
●
Right door. See
Right door on page 18.
●
Lower cassette pickup assembly. See
Lower cassette pickup assembly on page 56.
80 Chapter 1 Removal and replacement ENWW