Filter
Top Products
Fuser fan
1. Remove the front cover. See Front cover on page 11.
2. Disconnect one connector (callout 1), release the cable (callout 2) from the cable guide, release
two tabs (callout 3), and then remove the fuser fan (callout 4) from the product.
Figure 1-138 Remove the fuser fan
2
3
1
4
Reinstallation tip When reinstalling the fuser fan, make sure that the fan label (callout 1) and
the fan cable (callout 2) are positioned as shown in the figure below.
Figure 1-139 Reinstall the fuser fan
2
1
ENWW
Motors, fans, and clutches
89