Filter
Top Products
Paper deck paper deck controller PCAs
1. Remove the paper deck rear cover (see Paper deck rear cover on page 124).
2. Disconnect all of the connectors for the desired PCA.
●
The top PCA has seven connectors.
●
The middle PCA has six connectors.
●
The bottom PCA has five connectors.
3. Remove two screws (callout 1), release two tabs (callout 2), and then remove the PCA. Repeat this
procedure for the remaining PCAs.
NOTE: Some connectors (callout 3) on the PCAs are not used.
Figure 1-190 Remove the paper deck controller PCA
1
2
3
126 Chapter 1 Removal and replacement ENWW