Filter
Top Products
4. Release two tabs (callout 1), and then remove the cartridge door open detection switch from the
switch holder (callout 2).
Figure 1-116 Remove the cartridge door open detection switch (3 of 3)
12
1
Upper cassette media end switch
1. Remove the following components or assemblies:
●
Rear cover. See
Rear cover on page 13.
●
Low voltage power supply. See
Low-voltage power supply assembly on page 97.
2. Disconnect one connector (callout 1), remove one screw (callout 2), and then remove the upper
cassette media end switch (callout 3) from the product.
Figure 1-117 Remove the upper cassette media end switch
3
2
1
ENWW
Switches
75