Filter
Top Products
Duplex-reverse drive assembly
Before proceeding, remove the following components:
●
Right cover. See
Right cover on page 23.
●
Scanner assembly. See
Scanner assembly on page 26.
●
Simplex product
◦
Rear door. See
Rear door (simplex product) on page 33.
◦
Rear cover. See
Rear cover and feed guide (simplex product) on page 37.
●
Duplex product
◦
Rear-upper cover. See
Rear-upper cover (duplex product) on page 30.
◦
Rear door. See
Rear door (duplex product) on page 35.
◦
Rear-lower cover. See
Rear-lower cover and rear-door links (duplex product) on page 41.
●
Upper-cover assembly. See
Upper-cover assembly on page 51.
Remove the duplex-reverse drive assembly
1. Disconnect two connectors (callout 1), and then pass the connectors under the rear-door rib
assembly.
Figure 1-133 Remove the duplex-reverse drive assembly (1 of 4)
1
ENWW
Removal and replacement procedures
97