Filter
Top Products
Control panel and right-arm mount
1. Remove the Right cover. See Right cover on page 23.
2. Disconnect two FFCs and three connectors (callout 1) from the formatter PCA. Remove the USB
PCA connector from the retainer.
Figure 1-60 Remove the control panel and right-arm mount (1 of 3)
1
3. Remove three screws (callout 1) and disconnect the ground wire (callout 2).
Figure 1-61 Remove the control panel and right-arm mount (2 of 3)
1
2
48 Chapter 1 Removal and replacement ENWW