Filter
Top Products
4. Slide the control panel right-arm mount to the right to remove it from the scanner chassis.
Figure 1-62 Remove the control panel and right-arm mount (3 of 3)
Reinstall the control panel and right-arm mount
1. Slide the control panel right-arm mount assembly into the mounting points on the scanner chassis.
2. Install three screws (callout 1) and attach the grounding wire (callout 2).
IMPORTANT: The grounding wire and the two FFCs must move freely. If the grounding wire is
tangled with the FFCs, or is retracted too far into the control panel swivel, it might be too short to
reach the mounting point on the chassis.
Figure 1-63 Reinstall the control panel and right-arm mount (1 of 2)
1
2
ENWW
Removal and replacement procedures
49