Filter
Top Products
Power switch cable assembly
This section describes how to remove and install the power switch cable assembly.
Removing the power switch cable assembly
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Remove the expansion card support (see
Removing the expansion card support on page 77).
4. Remove the expansion card guide/front fan holder (see
Removing the expansion card guide/front
fan holder on page 126).
5. Remove the right side panel (see
Removing the right side panel on page 80).
6. Remove the front bezel (see
Removing the front bezel on page 85).
7. Disconnect the speaker (see
Removing the speaker on page 81).
8. Cut the cable ties
, and then move the power switch cable assembly screw
2
as shown in the
following figure.
Figure 5-20 Loosening the power switch cable assembly
9. Remove the cable assembly by pulling cables through the lower right chassis wall opening and the
front chassis wall opening.
90 Chapter 5 Replacing components ENWW