Filter
Top Products
Removing a hard disk drive from the hard drive bay
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Press the hard drive carrier release latch at the green touch point and rotate the handle outward
. Pull the drive carrier out of the hard drive bay as shown in the following figure
2
.
Figure 5-39 Removing the drive carrier from the chassis
4. Carefully separate the upper hard drive carrier rails, and then tilt the drive outward
2
as shown
in the following figure.
Figure 5-40 Removing the drive from the carrier
Carefully separate the lower carrier rails , and then remove the drive from the carrier.
106 Chapter 5 Replacing components ENWW