Filter
Top Products
Right side panel
This section describes how to remove and install the right side panel.
Removing the right side panel
NOTE: Use this procedure to access the backplane wiring.
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the two T-15 Torx screws
, and then slide the right side panel in the direction shown in
the following figure until it stops, and then lift off the chassis
2
.
Figure 5-10 Removing the right side panel
Installing the right side panel
To install the panel, slide it into position on the workstation, and then fasten it with two T-15 Torx screws.
Power supply
This section describes how to remove and install a power supply.
Removing the power supply
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
80 Chapter 5 Replacing components ENWW